Housed motors for garage door openers
These motors are produced with two different driving shaft ends. First type is motors with cylindrical shaft 28x74 with a keyway index CS. The second one is motor with special shaft with waved channels for a belt according to DIN 7868- index RS.
The joining holes of the flange can be 3 x M8 every 120 degrees or 4 x M8 every 90 degrees.
Degree of protection: IP40
Class of isolation: Class F (155 degrees Celsius)
Thermal protection: 130 degrees Celsius
Duty cycle: S2-2min.
Endings of the stator coil are lead through a hole in the rear shield. Length of the endings 500mm or longer based on request. It is also possible endings to be lead in a terminal board mounted on the rear shield. The terminal board is protected by a plastic cover.
These motors can be offered with a built-in electromagnetic brake too.
If you need additional information, we are at your disposal.
